Mazda 3 manuals

Mazda 3 Service Manual: Air Intake Actuator Inspection [Manual Air Conditioner]

Mazda 3 Service Manual / Engine / Intake / Air Intake Actuator Inspection [Manual Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table.



Terminal

Air intake actuator operation

B

C

B+

Ground

FRESH → RECIRCULATE

Ground

B+

RECIRCULATE → FRESH


Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. ...

Other materials:

Air Filter Removal/Installation [Skyactiv G 2.0]
1. Remove the fuel-filler pipe protector.. 2. Remove in the order indicated in the table. 1 Evaporative hose 2 Air filter 3. Install in the reverse order of removal. ...

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7. D ...

Windshield Wipers and Washer
The ignition must be switched ON to use the wipers. WARNING Use only windshield washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windshield, it will dirty the windshield, aff ect your visibility, and ...

� 2016-2026 Copyright www.mazda3tech.com