Mazda 3 manuals

Mazda 3 Service Manual: Drive Belt Inspection [Mzr 2.3 Disi Turbo]

Mazda 3 Service Manual / Engine / Belts, Hoses, Pulleys / Drive Belt Inspection [Mzr 2.3 Disi Turbo]

NOTE:

1. Verify that the drive belt auto tensioner indicator mark does not exceed the limit.


Drive Belt Inspection [Mzr 2.0, Mzr 2.5]
MZR 2.0 A/C drive belt NOTE: Drive belt deflection/tension inspection is not necessary because of the use of the maintenance-free type A/C drive belt. Replace the drive belt i ...

Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt NOTE: The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner. 1. Verify that the indicator pa ...

Other materials:

Fuel Gauge
The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full. Type A/Type B instrument cluster Type C instrument cluster If the low fuel warning light illuminates or the fuel level is very low, ...

Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
CAUTION: If foreign materials are stuck to the sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign materials such as iron filings are not stuck to the sensor during installation. 1. Perform t ...

Power Brake Unit Removal/Installation [Mzr 2.3 Disi Turbo]
CAUTION: Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again. Therefore, replace the switch with a new one when replacing the power brake unit or performing any procedure that changes the pedal stroke. Secure the steering wheel using tap ...

� 2016-2026 Copyright www.mazda3tech.com