Mazda 3 manuals

Mazda 3 Service Manual: Rollover Valve Removal/Installation [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Emissions / Rollover Valve Removal/Installation [Mzr 2.0, Mzr 2.5]

NOTE:

1. Remove the fuel tank..

Rollover Valve Inspection [Mzr 2.0, Mzr 2.5]
NOTE: The rollover valve cannot be disassembled and inspected as it is built into the fuel tank. 1. Perform the fuel tank inspection.. If there is any malfunction, replace the ...

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. ...

Other materials:

Relay Block Inspection [With Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Hood release lever. d. Upper panel. e. Shift knob (MTX)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].)(See MANUAL TRANSAX ...

Starter Interlock Switch Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connec ...

Driver Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. 1. Switch the ignition to off. 2. Disconnect the negative batte ...

� 2016-2026 Copyright www.mazda3tech.com