Mazda 3 manuals

Mazda 3 Service Manual: Air Filter Inspection

Mazda 3 Service Manual / HVAC / General / Air Filter Inspection

1. Verify that there is no damage, excessive dirt, or abnormal odor on the air filter.

NOTE:

General
...

Air Filter Inspection [Mzr 2.0, Mzr 2.5]
Except for Mexico Airflow inspection 1. Remove the air filter.. 2. Blow from port A and verify that there is airflow from port B. If there is no airflow, replace the air filter.. ...

Other materials:

Fuel Gauge Sender Unit Inspection
MZR 2.3 DISI Turbo, SKYACTIV-G 2.0 NOTE: The fuel gauge sender unit is integrated with the fuel pump unit. 1. Disconnect the negative battery cable.. 2. Remove the rear seat cushion.. 3. Remove the fuel pump unit.. 4. Verify that the resistance between terminals A and C of the f ...

Transaxle Oil Inspection [G66 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. If the oil level is lower than the low level, add the specified amount and type of oil through the ...

Wheel Hub, Steering Knuckle Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

� 2016-2026 Copyright www.mazda3tech.com