Mazda 3 manuals

Mazda 3 Service Manual: Base Removal

1. Remove the rearview mirror..

2. Wind each end of a wire around a bar.


WARNING:

NOTE:

3. Fix one end of the piano wire, and while pulling the other end, cut the sealant to remove the base.

Base Installation
1. Cut away all of the original sealant using a razor. WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor. 2. Clean and degrease the cera ...

Filament Inspection
1. Turn the ignition switch to the ON position. 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the teste ...

Other materials:

Starter Cut Relay Removal/Installation [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable.. 2. Remove the following parts: Front scuff plate (LH). Front side trim (LH). Side wall. Console. 3. Set the hood release lever out of the way.. 4. Remove the ...

Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings before handling the air bag module.. 1. Remove the driver-side front scuff plate.. 2. Remove the driver-side front sid ...

Fuel Gauge Sender Unit Removal/Installation
MZR 2.0, MZR 2.5 NOTE: Fuel pump unit cannot be disassembled. 1. Remove the fuel gauge sender unit.. MZR 2.3 DISI Turbo NOTE: Fuel pump unit cannot be disassembled. 1. Remove the fuel gauge sender unit.. SKYACTIV-G 2.0 NOTE: Fuel pump unit cannot be disasse ...

� 2016-2026 Copyright www.mazda3tech.com