Mazda 3 manuals

Mazda 3 Service Manual: Glass Antenna

Purpose, Function

Construction


Fail-safe

Front Power Window Regulator Removal/Installation
1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm { ...

Glass Antenna Inspection
4SD 1. Disconnect the negative battery cable.. 2. Disconnect the antenna amplifier connector B.. 3. Disconnect the antenna feeder No.3 connector C. (with audio unit (with display)). 4. Inspect ...

Other materials:

Roof Molding Removal
1. Insert a fastener remover in the position shown in the figure. 2. Rotate the flathead screwdriver in the direction of the arrow (1) shown in the figure and remove the roof molding from the T-stud (figure A). 3. Rotate the roof molding in the direction of the arrow (2) shown in the figure, ...

Oil Cooler Flushing [FS5 A EL]
NOTE: If the automatic transaxle is replaced, flush and inspect the oil cooler. When replacing the automatic transaxle, inspect the oil cooler together with flushing it using the following procedures, and with the oil cooler hose removed. 1. Disconnect the oil hose. 2. Set ...

High Mount Brake Light Bulb Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove in the order indicated in the table. 1 Connector 2 Socket 3 High-mount brake light bulb 4. Install in the rev ...

� 2016-2026 Copyright www.mazda3tech.com