Type |
Playable data |
USB mode | MP3/WMA/AAC file |
This unit does not support a USB 3.0 device. In addition, other devices may not be supported depending on the model or OS version.
Playback
NOTE
Pause
To stop playback, press the play/pause button ( 4 ).
Press the button again to resume playback.
Fast-forward/Reverse
Press and hold the fast-forward button (
)
to advance through a track at high speed.
Press and hold the reverse button (
) to
reverse through a track at high speed.
Track search
Press the track up button ( )
once to skip
forward to the beginning of the next track.
Press the track down button ( )
within a
few seconds after playback begins to track
down to the beginning of the previous
track.
Press the track down button ( )
after a
few seconds have elapsed to start playback
from the beginning of the current track.
Folder search
To change to the previous folder, press the
folder down button ( ), or press
the folder
up button ( ) to advance to the
next
folder.
Music scan
This function scans the titles in a folder currently being played and plays ten seconds of each song to aid you in finding a song you want to listen to.
Press and hold the scan button ( )
during playback to start the scan play
operation (the track number will flash).
Press and hold the scan button ( )
again to cancel scan playback.
NOTE If the unit is left in scan, normal playback will resume where scan was selected.
Repeat playback
Track repeat
Folder repeat
“ FOLDER RPT ” is displayed (
is
displayed next to RPT at the bottom of
the display area).
Random playback
Tracks are randomly selected and played.
Folder random
All random
“ ALL RDM ” is displayed ( is
displayed next to RDM at the bottom of
the display area).
Switching the display
The information displayed on the audio display changes as follows each time the text button ( 3 ) is pressed during playback.
NOTE
Display scroll
Only 13 characters can be displayed at one time. To display the rest of the characters of a long title, press and hold the text button ( 3 ). The display scrolls the next 13 characters. Press and hold the text button ( 3 ) again after the last 13 characters have been displayed to return to the beginning of the title.
NOTE The number of characters which can be displayed is restricted.
Error Messages
When the message “ CHECK USB ” is displayed, it indicates that there is some error in the USB device. Verify that the content recorded in the USB device has MP3/WMA/AAC files and re-connect correctly. If the message reappears, have the unit checked by an Authorized Mazda Dealer.
Front Door Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Remove the front door speaker..
5. Verify the resistance between the front door speaker terminals.
If not within the specification, replace the front door speaker.
...
On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL]
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the IDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “TCM”.
3. Select the applicable PID from the PID table.
4. Verify the PID data a ...
Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures
WARNING:
A live (undeployed) air bag module or pre-tensioner seat belt may accidentally
operate (deploy) when it is disposed of and cause serious injury. Always refer
to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and
dispose of air bag modules and pre-t ...