Mazda 3 Owners Manual: Operating Tips for iPod

Mazda 3 Owners Manual / Interior Features / Audio System / Operating Tips for Audio System / Operating Tips for iPod

This unit supports playback of music files recorded to an iPod.

iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

The iPod may not be compatible depending on the model or OS version. In this case, an error message is displayed.

CAUTION

Remove the iPod when it is not in use. Because the iPod is not designed to withstand excessive changes in temperature inside the cabin, it could be damaged or the battery may deteriorate due to the excessive temperature or humidity inside the cabin if it is left in the vehicle.
If data in the iPod is lost while it is connected to the unit, Mazda cannot guarantee recovery of any lost data.
If the iPod battery is deteriorated, the iPod may not recharge and playback may not be possible when it is connected to the unit.
Be careful not to pinch the iPod connecting cable when opening/closing the center console.
For details on using the iPod, refer to the iPod instruction manual.
When connecting the iPod to a USB port, all commands are made from the audio unit. iPod control is not possible.

NOTE The audio unit cannot display images or videos stored in an iPod.

Operating Tips for USB device

This unit plays audio files as follows: *1 Type B CAUTION Do not use an audio fi le extension on fi les other than audio fi les. In addition, do not change the audio fi le extens ...

Audio Set (Type A)

Power/Volume/Sound Controls Clock Operating the Radio Operating the Compact Disc (CD) Player How to use Auxiliary jack/USB port Error Indications ...

Other materials:

Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor control module is replaced with a new one, perform the seat weight sensor calibration using the M–MDS.. 1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Disconnect the connectors. ...

Outer Mirror Garnish Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the outer mirror glass from the outer mirror.. 3. Pinch the end of the tab which is visible, and release the tab by pressing it toward the vehicle front (3 locations). 4. Grasp the upper side of the outer mirror garnish and remove it b ...

M Position Switch Inspection [FS5 A EL]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the console.. d. Disconnect the selector lever component connector. 2. Inspect the continuity between the selector lever component terminals A and H. If ...