Mazda 3 manuals

Mazda 3 Service Manual: Power Outer Mirror Removal/Installation

Mazda 3 Service Manual / Body / Mirrors / Power Outer Mirror Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the inner garnish..

3. Remove the front door trim..

4. Disconnect the power outer mirror connector.


5. Remove the bolts.

6. Remove the power outer mirror.

7. Install in the reverse order of removal.

Power Outer Mirror Inspection
Mirror Glass Adjustment Motor 1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Disconnect the power outer mirror connector. 4. Remove the front door trim.. 5. Apply ...

Rearview Mirror Installation
1. Install the rearview mirror onto the base. 2. Connect the negative battery cable. (vehicles with auto light/wiper system). ...

Other materials:

Side Step Molding Removal
1. Remove the fasteners A. 2. Using the removal tool, disengage clips B in the direction of the arrow (1), (2) shown in the figure. NOTE: Leave the disengaged clip B in place in consideration of the servicing. 3. Slide the side step molding in the direction of the arrow ( ...

Clutch Pipe And Hose Removal/Installation [C66 M R]
CAUTION: Do not allow clutch fluid get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely. 1. Remove the battery cover.. 2. Disconnec ...

Variable Valve Timing Actuator Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Variable valve timing actuator can not be disassembled because it is a precision unit. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remo ...

� 2016-2026 Copyright www.mazda3tech.com