Mazda 3 manuals

Mazda 3 Service Manual: Power Window System Initialization Procedure

Mazda 3 Service Manual / Body / Glass & Windows / Power Window System Initialization Procedure

NOTE:

1. Switch the ignition to ON.

2. Press the driver's seat switch to fully open the door glass.

3. Pull up the driver's seat switch to the manual-up position to fully close the door glass and keep holding the switch up at the position for approx. 2 s

.

Power Window Subswitch Removal/Installation
Passenger's Side 1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Remove the power window subswitch.. 5. Install in the reverse ...

Power Window System Preliminary Inspection [Power Window System]
Manual Open/close Function Inspection STEP INSPECTION ACTION 1 Switch the ignition to ON. Operate the ...

Other materials:

Rear Center Seat Belt Removal/Installation
CAUTION: The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor. 4SD 1. Remove the following parts: ...

M Position Switch Inspection [Fw6 A EL]
Continuity Inspection NOTE: The M position switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the console.. 4. Disconnect the selector lever component connector. 5. Verify that the continuit ...

Hood Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the hood latch.. 3. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the hood latch. NOTE: Press the latch lever in using a flathead screwdriver to inspect the c ...

� 2016-2026 Copyright www.mazda3tech.com