Mazda 3 manuals

Mazda 3 Service Manual: ABS

Precaution [Dynamic Stability Control (DSC)]
1. The ABS warning light and/or brake system warning light and/or DSC indicator light and/or DSC OFF light illuminate even when the system is normal. Warning lights that may ...

ABS HU/CM Inspection
1. Disconnect the ABS HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the ABS HU/CM wiring harness-side connector and inspect the voltage, continuity, or r ...

Other materials:

Front Door Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Move the hook in the direction of arrow shown in the figure using a tape-lapped flathead screwdriver and detach it from the front door trim. CAUTION: Affix protective tape to the front door trim and assis ...

Rear View Monitor Operation
The operation of the rear view monitor when reversing the vehicle varies depending on the traffic, road, and vehicle conditions. The amount of steering and the timing also varies depending on conditions, so confirm the surrounding conditions directly with your eyes and steer the vehicle in ...

Rear Bumper Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the fastener A and screw B. 4. Remove the rear splash shield.. 5. Remove the screws C. 6. Remove the bolts D. 7. Affix the protective tape to the position shown in the figure. ...

� 2016-2026 Copyright www.mazda3tech.com