Mazda 3 manuals

Mazda 3 Service Manual: Blower Motor Inspection [Manual Air Conditioner]

Mazda 3 Service Manual / HVAC / A/C / Blower Motor Inspection [Manual Air Conditioner]

1. Connect battery positive voltage to blower motor terminal A, connect terminal B to ground, and then verify its operation.


Blower Motor Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to blower motor terminal A, connect terminal B to ground, and then verify its operation. If there is any malfunction, replace the blower motor. ...

Blower Motor Installation [Full Auto Air Conditioner]
1. Install the SST (49 B061 015A) to the blower motor. 2. Install the blower motor with the SST (49 B061 015A) installed, to the A/C unit. CAUTION: To prevent damage to the siroc ...

Other materials:

Cooling System Service Warnings [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Blind Spot Monitoring (Bsm) Off Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the switch panel in the direction of the arrow shown in the figure. 3. Disconnect the connector. 4. Remove the BSM OFF switch in the direction of the arrow (2) shown in the figure while pressing the tabs in the direction of the arrow ...

Windshield Wipers
Turn the wipers on by pressing the lever up or down. With intermittent wiper Variable-speed intermittent wipers Set the lever to the intermittent position and choose the interval timing by rotating the ring. With auto-wiper control Auto-wiper control When the wiper lever is ...

� 2016-2026 Copyright www.mazda3tech.com