CAUTION:
Do not clean the clutch release collar with cleaning fluids or a steam cleaner because it is filled with grease.
Operation Inspection
1. Turn the collar while applying force in the axial direction, and inspect for sticking, excessive resistance, and an abnormal noise.

If there is any malfunction, replace the clutch release collar..
Clutch Pipe And Hose Removal/Installation [C66 M R]
Clutch Release Cylinder Removal/Installation [C66 M R]Door Sash Film Installation
1. Remove any grease or dirt from the affixing surface of the door.
2. Cut away the unused portion along the dotted lines.
3. Peel off the backing paper and attach the door sash film onto the door as
shown in the figure.
Standard clearance
a: 3.0—5.0 mm {0.12—0.19 in}
...
Body Control Module (Bcm) Configuration
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial
screen of the M-MDS.
When using the IDS (laptop PC)
Select “Module Programming”.
Select “Programmable Module Installation”.
Select ...
Electrical System
Electrical Parts
Battery cable
Before disconnecting connectors or removing electrical parts, disconnect
the negative battery cable.
Wiring Harness
To remove the wiring harness from the clip in the engine room, pry up the
hook of the clip using a flathead screwdriver. ...