Mazda 3 manuals

Mazda 3 Service Manual: Evaporator Inspection

Mazda 3 Service Manual / HVAC / A/C / Evaporator Inspection

1. Inspect the evaporator for damage, cracks, and oil leakage.

2. Visually inspect the fins for bending.

Drive Belt Removal/Installation [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. NOTE: Remove/install the drive belt from the underside of the veh ...

Expansion Valve Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant from the system.. CAUTION: If moisture or foreign material enters the refrigeration cycle, cooling ability will b ...

Other materials:

Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear scuff plate. b. Rear seat cushion. c. Rear seat back. d. Lower anchor installation bolts on the rear seat belt. e. Tire house trim. f. Trunk end trim. g. Trunk side upper trim. h. Trunk side trim. i ...

Engine Tune Up [Skyactiv G 2.0]
Engine Tune-up Preparation NOTE: If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction. The engine s ...

Locking, Unlocking with Door- Lock Knob
Operation from inside To lock any door from the inside, press the door-lock knob. To unlock, pull it outward. This does not operate the other door locks. NOTE The red indication can be seen when the door-lock knob is unlocked. Operation from outside To lock the rear and front pa ...

� 2016-2026 Copyright www.mazda3tech.com