Mazda 3 manuals

Mazda 3 Service Manual: Rear Tilt Motor Inspection

Mazda 3 Service Manual / Body / Seats / Rear Tilt Motor Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait 1 min or more

..

3. Disconnect the rear tilt motor connector.

4. Apply battery positive voltage to the rear tilt motor terminals and inspect the rear tilt motor operation



Motor operation

Connection

B+

GND

Up

B

D

Down

D

B


Rear Seat Cushion Trim Removal/Installation
1. Remove the rear seat cushion.. 2. Remove rings C, then remove the seat cushion trim from the seat cushion pad. 3. Install in the reverse order of removal. ...

Recliner Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the recliner motor connector. 4. Apply battery positive voltage to the recliner moto ...

Other materials:

Blower Motor Removal [Manual Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

Driver Side Air Bag Module Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. Due to the adoption of 2-step deployment control in the driver- ...

Wheel Balance Adjustment
CAUTION: Adjust the outer wheel balance first, then the inner wheel balance. Be careful not to scratch the wheels. Adhesive-type Balance Weight (Outer) 1. Remove the old balance weight from the wheel. 2. Remove the double-sided adhesive tape remaining on the wheel, then clea ...

� 2016-2026 Copyright www.mazda3tech.com