Mazda 3 manuals

Mazda 3 Service Manual: Rearview Mirror Removal

Mazda 3 Service Manual / Body / Mirrors / Rearview Mirror Removal

1. Insert a tape-wrapped flathead screwdriver to the position shown in the figure and press the center part of the spring in the direction of arrows (1), and then pull out the rearview mirror in the direction of arrows (2) shown in the figure.


CAUTION:

Rearview Mirror Installation
1. Install the rearview mirror onto the base. 2. Connect the negative battery cable. (vehicles with auto light/wiper system). ...

Vanity Mirror Illumination Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole, and pry it in the direction indicated by the arrow to remove the lens. 3. Remove t ...

Other materials:

Forward Sensing Camera (FSC)
Your vehicle is equipped with a Forward Sensing Camera (FSC). The Forward Sensing Camera (FSC) is positioned near the rearview mirror and used by the following systems. High Beam Control System (HBC) Lane Departure Warning System (LDWS) The Forward Sensing Camera (FSC) determines t ...

PCM Configuration [Mzr 2.0, Mzr 2.5]
CAUTION: If the wheel and tire sizes are changed, a discrepancy with the speedometer needle whereby it exceeds the allowable range could result in a malfunction. If the wheel and tire sizes are changed, perform the following procedure to change the tire size parameter setting.. ...

Rear Stabilizer Control Link Inspection
1. Remove the rear stabilizer control link from the vehicle.. 2. Inspect for bending or damage. If there is any malfunction, replace the rear stabilizer control link. 3. Rotate the ball joint stud 10 times and shake it side to side 10 times. 4. Measure the ball joint rotational torque usin ...

� 2016-2026 Copyright www.mazda3tech.com