Mazda 3 Owners Manual: Scheduled Maintenance

Essential Information

Be extremely careful and prevent injury to yourself and others or damage to your vehicle when using this manual for inspection and maintenance. If you are unsure about any procedure it describes ...

Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)

Follow Schedule 1 if the vehicle is operated mainly where none of the following conditions (severe driving conditions)apply. Repeated short-distance driving Driving in dusty conditions Driv ...

Other materials:

Joint Shaft Removal/Installation [Mzr 2.0, Mzr 2.3 Disi Turbo, Mzr 2.5]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor connector (axle side) and ...

Blind Spot Monitoring (Bsm) Bracket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Remove the BSM control module.. 5. Remove the nuts. 6. Remove the clip. 7. Remove the BSM bracket. 8. Install in the reverse order of removal. 9. Perform the blind ...

Air Bleeding
CAUTION: If the strainer is removed, impurities may penetrate the power steering system and damage it. To prevent this, always bleed air with the strainer installed. Do not maintain the steering wheel fully turned for 5 s or more. The oil temperature could rise and damage ...