Mazda 3 manuals

Mazda 3 Owners Manual: Active Driving Display Does Not Operate

Mazda 3 Owners Manual / If Trouble Arises / Active Driving Display Does Not Operate

If the Active Driving Display Does Not Operate

If the active driving display does not operate, switch the ignition off and then restart the engine. If the active driving display does not operate even with the engine restarted, have the vehicle inspected at an Authorized Mazda Dealer.

When Liftgate/Trunk Lid Cannot be Opened
If the vehicle battery is dead or there is a malfunction in the electrical system and the liftgate/trunk lid cannot be opened, perform the following procedure as an emergency measure to open it: ...

Customer Information and Reporting Safety Defects
Important consumer information including warranties and add-on equipment. ...

Other materials:

Rear Oil Seal Replacement [Mzr 2.0, Mzr 2.5]
1. Remove the transaxle.. 2. Remove the flywheel (MTX) or the drive plate (ATX).. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 Bolt 2 Rear oil seal (See Rear Oil Seal Installation Note. ...

Auxiliary Jack/Usb Port Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift lever knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. 3. Remove the auxiliary jack/USB port in the direction of the arrow (2) shown in the figure w ...

Door Adjustment
1. Loosen the door hinge installation bolts. 2. Adjust the gap and height difference to the standard range by moving the door back and forth, left and right. Standard range a: 2.5―4.5 mm {0.10―0.17 in} b: -1.0―1.0 mm {-0.039―0.039 in} c: 2.5& ...

� 2016-2026 Copyright www.mazda3tech.com