Mazda 3 Service Manual: Fuel Shut Off Valve Inspection [Mzr 2.0, Mzr 2.5]
Except for Mexico
NOTE:
-
The fuel shut-off valve cannot be removed and inspected as it is built into the fuel tank.
1. Perform the fuel tank inspection..
-
If there is any malfunction, replace the fuel tank.
Fuel Pump Unit Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin ...
Fuel Shut Off Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
Except for Mexico
NOTE:
The fuel shut-off valve cannot be removed as it is built into the fuel tank.
1. Remove the fuel tank.. ...
Other materials:
Hazard Warning Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the center panel..
3. Verify that the continuity between the hazard switch terminals is as indicated
in the table.
If not as indicated in the table, replace the hazard warning switch.
4. Apply battery voltage to hazar ...
Heater Core Inspection
1. Inspect the heater core for damage, cracks, and water leakage.
If there is any malfunction, replace the heater core.
2. Visually inspect the fins for bending.
If there is any bending, use the end of a flathead screwdriver to straighten
the fins.
3. Visually inspect ...
Transaxle Fluid Temperature (Tft) Sensor Inspection [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
On-Vehicle Inspection
1. Perform the following procedures.
a. Remove the battery cover..
b. ...
