Mazda 3 Owners Manual: Rear Window Wiper and Washer
The ignition must be switched ON to use the wiper.
Rear Window Wiper
Turn the wiper on by turning the rear wiper/washer switch
Rear Window Washer
To spray washer fluid, turn the rear wiper/ washer switch to the position. After the switch is released, the washer will stop.
If the washer does not work, inspect the fluid level . If the fluid level is normal and the washer still does not work, consult an Authorized Mazda Dealer.
Windshield Washer
Pull the lever toward you and hold it to
spray washer fluid.
NOTE
With the wiper lever in the or
intermittent position/ position, the
wipers will operate continuously until the
lever is rele ...
Rear Window Defogger
The rear window defogger clears fog from
the rear window.
The ignition must be switched ON to use
the defogger.
Press the switch to turn on the rear
window defogger. The rear window
defogger ...
Other materials:
Hood Disassembly/Assembly
Except Mazdaspeed3
1. Disassemble in the order indicated in the table.
1
Weather strip parting seal
2
Weather strip shroud seal
3
Fasteners A
4
Fasteners B
5
...
Positive Crankcase Ventilation (PCV) Valve Inspection [Mzr 2.0, Mzr 2.5]
Airflow Inspection
1. Disconnect the section (A) of the ventilation hose shown in the figure.
2. Start the engine and verify that vacuum is applied to the end of the disconnected
ventilation hose while the engine is idling.
NOTE:
Because it is difficult to directly inspect the PC ...
Gauges and meters
In the Subaru Solterra, the gauges and meters are designed to provide
the driver with clear, real-time driving information, helping to maintain awareness
of vehicle performance, battery condition, and overall system status during every
journey.
Meter display
■ Locations of gauges and meter ...
