Mazda 3 manuals

Mazda 3 Service Manual: Thermostat Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Cooling / Thermostat Inspection [Mzr 2.0, Mzr 2.5]

1. Remove the thermostat..

2. Visually check that the thermostat valve is closed.

3. Place the thermostat in water.

WARNING:

4. Heat the water and check the following.

Water Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Thermostat Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Other materials:

If the vehicle is submerged or water on the road is rising
The Subaru Solterra is not intended for operation in deep or rising water conditions. Avoid driving through flooded roads, as this can lead to loss of control, electrical damage, or the vehicle becoming stranded. If there is a risk of the Subaru Solterra being submerged, remain calm and follo ...

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. Dashboard under cover. d. Glove compartment. e. Lower panel (Passenger-side). f. Shower duct ( ...

Dashboard Removal/Installation
1. Set the air intake mode to FRESH. 2. Set the air mix mode to MAX COLD. 3. Disconnect the negative battery cable.. 4. Remove the following parts: a. Front doors. b. Front scuff plate. c. Front side trim. d. Dashboard under cover. e. Glove compartment. f. Upper panel. g. Shift l ...

� 2016-2026 Copyright www.mazda3tech.com