Mazda 3 manuals

Mazda 3 Owners Manual: Cooling (With air conditioner)

  1. Set the mode selector dial to the
    position.
  2. Set the temperature control dial to the cold position.
  3. Set the fan control dial to the desired speed.
  4. Turn on the air conditioner by pressing the A/C switch.
  5. After cooling begins, adjust the fan control dial and temperature control dial as needed to maintain maximum comfort.
CAUTION If the air conditioner is used while driving up long hills or in heavy traffi c, monitor the engine coolant temperature warning light to see if it is illuminated or fl ashing .

The air conditioner may cause engine overheating. If the warning light is illuminated or fl ashing, turn the air conditioning off .

NOTE

Ventilation

  1. Set the mode selector dial to the
    position.
  2. Set the air intake selector to the outside air position.
  3. Set the temperature control dial to the desired position.
  4. Set the fan control dial to the desired speed.
Heating
Set the mode selector dial to the position. Set the air intake selector to the outside air position. Set the temperature control dial to the hot position. Set the fan control dial to ...

Windshield Defrosting and Defogging
Set the mode selector dial to the position. Set the temperature control dial to the desired position. Set the fan control dial to the desired speed. If dehumidified heating is desire ...

Other materials:

Airflow Mode Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH. 2. Set the air mix mode to MAX COLD. 3. Disconnect the negative battery cable.. 4. Remove the following parts: a. Front doors. b. Front scuff plate. c. Front side trim. d. Dashboard under cover. e. Glove compartment. f. Upper panel. g. Shift l ...

Rear Wiper Arm And Blade Removal/Installation
1. Remove in the order indicated in the table. 1 Cap 2 Nut 3 Rear wiper arm (See Rear Wiper Arm Installation Note.) 4 Rear wiper blade 5 Rubber brush ...

Wheel Unit ID Registration
NOTE: After the wheel unit replacement, registration of the wheel unit identification codes must be performed. ID registration can be done using the M-MDS, or not using the M-MDS. Using M-MDS 1. Connect the M-MDS to DLC-2. 2. After the vehicle is identified, select th ...

� 2016-2026 Copyright www.mazda3tech.com