Mazda 3 manuals

Mazda 3 Service Manual: Sensors, Switches, Relays

Mazda 3 Service Manual / Brakes / Sensors, Switches, Relays

Parking Brake Switch Inspection
1. Remove the upper panel.. 2. Disconnect the parking brake switch connector. 3. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the ...

Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder. 2. Inspect for continuity according to fluid level between the brake fluid level sensor terminals. If no ...

Other materials:

Drive Belt Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2. Rotate the drive belt auto tensioner in the direction shown in the figure and remove the drive belt. 3. Install the drive belt. 4. Verify that the drive belt auto tensioner indicator mark does not exceed ...

Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
HO2S Inspection 1. Connect the M-MDS to the DLC-2. 2. Switch the ignition to ON. 3. Warm up the engine to normal operating temperature. 4. Access the following PIDs using the M-MDS.. VSS (Vehicle speed) RPM (Engine speed) O2S12 (HO2S output voltage) 5. Drive ...

Transaxle Oil Replacement [G35 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and washer. 4. Drain the oil into a suitable container. 5. Install a new washer and the drain plug. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf} ...

� 2016-2026 Copyright www.mazda3tech.com