Mazda 3 manuals

Mazda 3 Service Manual: Front Suspension

Mazda 3 Service Manual / Suspension / Front Suspension

Wheel Hub Component Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Front Lower Arm Inspection
1. Remove the front lower arm from the vehicle.. 2. Inspect the arm for bending or damage, and the ball joint for excessive looseness. If there is any malfunction, replace the front lower a ...

Other materials:

Brake/Clutch Fluid
Inspecting Brake/Clutch Fluid Level WARNING If the brake/clutch fl uid level is low, have the brakes inspected: A low brake/clutch fl uid level is dangerous. A low level could indicate brake lining wear or a brake system leak which could cause the brakes to fail and lead ...

Front Passenger Occupant Classification System
First, please read "Supplemental Restraint System (SRS) Precautions" carefully. Front Passenger Seat Weight Sensor Your vehicle is equipped with a front passenger seat weight sensors as a part of the supplemental restraint system. These sensors are located under both of the front p ...

Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Drain the engine coolant.. 4. Remove the battery and b ...

� 2016-2026 Copyright www.mazda3tech.com