Mazda 3 manuals

Mazda 3 Service Manual: General

Lighting & Horn
...

Auto Leveling Sensor Inspection
1. Disconnect the negative battery cable.. 2. Remove the auto leveling sensor.. 3. Connect the three dry cell batteries (1.5 V) in a series. 4. Connect auto leveling sensor terminal A to the ...

Other materials:

Front Scuff Plate Removal/Installation
1. Detach tab A while pulling the front scuff plate in the direction of the arrow (1) shown in the figure, then detach hook B, clips C, and pins D while pulling in the direction of the arrow (2). 2. Detach tab E while pulling the front scuff plate in the direction of the arrow (3) shown in t ...

Sirius Satellite Radio Unit Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Passenger-side front scuff plate. b. Passenger-side front side trim. c. Dashboard under cover. d. Grove compartment. e. Passenger-side lower panel. 3. Remove in the order indicated in the table. ...

DSC HU/CM Inspection
1. Disconnect the DSC HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the DSC HU/CM wiring harness-side connector and inspect voltage, continuity, or resistance according to the standard (reference) on the table. Standard (Reference) ...

� 2016-2026 Copyright www.mazda3tech.com