Mazda 3 manuals

Mazda 3 Service Manual: Body Exterior, Frame

Mazda 3 Service Manual / Body / Body Exterior, Frame

Trunk Lid Trim Removal/Installation
1. Remove the fasteners, then remove the trunk lid trim. 2. Install in the reverse order of removal. ...

Aerodynamic Under Cover No.1 Removal/Installation
1. Remove the aerodynamic under cover No.2.. 2. Peel off the front mudguard.. 3. Remove the bolts and fastener. 4. Remove the aerodynamic under cover No.1 in the direction of the arrow shown ...

Other materials:

Oil Seal (Differential) Replacement [G66 M R]
1. On level ground, jack up the vehicle and support it evenly on safety stands. 2. Remove the aerodynamic under cover No.2.. 3. Drain the oil from the transaxle.. 4. Remove the front splash shield.. 5. Separate the drive shaft and joint shaft from the transaxle.. 6. Remove the oil seals u ...

Keyless Antenna Removal/Installation
Interior, Front 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Center panel. g. Audio unit. h. Rear heat duct (1). 3. Disconnect the connector. 4. ...

RSA (Road Sign Assist)
In the Subaru Solterra, the Road Sign Assist (RSA) system uses the front camera and, when available, navigation data to identify traffic signs such as speed limits and restrictions. Once recognized, the system provides clear visual alerts and, when necessary, audible warnings to help keep the ...

� 2016-2026 Copyright www.mazda3tech.com